Table of Contents
Advertisement
Charging a spare rechargeable battery
A rechargeable Li-ion battery can be charged when it is not inside the monitor. The Charging
cradle is designed to accommodate both types of charging. Contacts on the bottom of the
battery meet the contacts on the Charging cradle, transferring power without other
connections, and a spring-loaded capture holds the battery in place during charging.
1. Plug the AC/DC adapter into the monitor's Charging cradle.
2. Place the battery into the Charging cradle, with the gold-plated contacts on top of the six
matching charging pins.
3. Plug the AC/DC adapter into the wall outlet.
The battery begins charging automatically. During charging, the Secondary LED in the
Charging cradle blinks green. When charging is complete, it glows steady green.
Release the battery from the Charging cradle by pulling it back toward the rear of the Charging
cradle and tilting it out of its slot.
Note: If you need to replace the Li-ion battery pack, replacements are available from Honeywell.
The part number is 059-3051-000.
Note: An Alkaline Battery Adapter (part number 059-3052-000), which uses four AA alkaline
batteries (Duracell MN1500), may be substituted for the Li-Ion battery.
To reduce the risk of ignition of hazardous atmospheres, recharge and replace
batteries only in areas known to be non-hazardous. Remove and replace batteries
only in areas known to be non-hazardous.
Replacing rechargeable Li-Ion battery
Turn off the instrument before removing or replacing the battery.
Low voltage warning
When the battery's charge falls below a preset voltage, the instrument warns you by
beeping once and flashing once every minute, and the "empty battery" icon blinks on and
off once per second. You should turn off the instrument within 10 minutes and either
recharge the battery by placing the instrument in its Charging cradle, or replace the
battery with a fresh one with a full charge.
Handheld PID Monitors
WARNING
CAUTION
19
User Manual
Advertisement
Table of Contents
