Once you enter Programming Mode, the LCD displays the first menu, Calibration. Each
subsequent menu is accessed by pressing [N/ ] repeatedly until the desired menu is displayed.
To enter a sub-menu of a menu, press [Y/+].
Exiting programming mode
To exit Programming Mode and return to normal operation, press [MODE] once at any of the
programming menu displays. You will see "Updating Settings..." as changes are registered and
the mode changes.
Navigating programming mode menus
Navigating through the Programming Mode menus is easy and consistent, using a single
interface format of "Select," "Back" and "Next" at the top level. The three control buttons
correspond to these choices as shown:
Note: Pressing [MODE] in the Programming Mode's top level causes the instrument to exit
Programming Mode and return to monitoring.
The three keys perform the following functions in Programming Mode:
Key
[MODE]:
Exit menu when pressed momentarily or exit data entry mode
[Y/+]:
Increase alphanumerical value for data entry or confirm (yes) for a question
[N/-]:
Provides a "no" response to a question
Handheld PID Monitors
Function in Programming Mode
72
Mesh Channel*
Mesh Interval*
LCD Contrast*
User Manual