Honeywell MiniRAE 3000+ User Manual page 91

Lamp ID
The instrument does not automatically identify the type of lamp installed. If the lamp type is
replaced with a different UV Lamp energy, you must select the lamp type.
1. Scroll through the menu by pressing [N/-].
2. Press [Y/+] to make a selection.
3. Press [MODE] when you are done.
4. Press [Y/+] to save your choice or [N/-] to undo your selection.
PAN ID
The instrument and any other devices that you want to interconnect wirelessly must have the
same PAN ID. You can set the PAN ID in the instrument or through Safety Suite Device
Configurator (SSDC).
1. Press [N/-] to advance through the digits from left to right.
2. Press [Y/+] to ] to advance through the numbers (1, 2, 3, etc.).
3. Press [MODE] to register your choice when you are done.
Note: PAN ID only applies to instruments equipped with a MESH Radio Modem, not BLE or BT.
Mesh channel
Note: For mesh radio modems operating at 868MHz, only channel 0 is available. For other
frequencies, channels 1 through 10 are allowed.
1. Press [Y/+] to increase the number and [N/-] to advance to the next digit.
2. After moving to the last digit and making changes, press [MODE].
Press [Y/+] to save the change.
l
Press [N/-] to undo the change.
l
Note: Mesh Channel only applies to instruments equipped with a MESH Radio Modem, not BLE
or BT.
Handheld PID Monitors 91 User Manual