Interval
Intervals are shown in seconds. The default value is 60 seconds. The maximum interval is 3600
seconds.
1. Press [Y/+] to increase each digit's value.
2. Press [N/-] to advance to the next digit.
3. Again, use [Y/+] to increase the number.
Repeat this process until all numbers are entered.
When you have completed your selections, press [MODE].
You will see two choices: Save and Undo. You can register the new settings or to change your
mind and revert to your previous settings.
Press [Y/+] to save the changes.
l
Press [N/-] to undo the changes and revert to the previous settings.
l
Data selection
Data Selection allows you to select which types of data are stored and made available when you
offload your datalog to a computer via Safety Suite Device Configurator (SSDC) software.
You can choose any or all of four types of data (you must choose at least one):
Average
l
Maximum
l
Minimum
l
Realtime
l
1. Press [N/-] to step from one option to the next. The highlighter indicates your choice.
2. Press [Y/+] to toggle your selection on or off (the check box indicates "on" with an "X").
3. When you have completed your selections, press [MODE].
You will see two choices: Save and Undo. You can register the new settings or to change your
mind and revert to your previous settings.
Press [Y/+] to save the changes.
l
Press [N/-] to undo the changes and revert to the previous settings.
l
Handheld PID Monitors
83
User Manual