To begin measuring, turn on the UltraRAE 3000+. This screen is shown, which includes the CF
(correction factor) and measurement gas type for calibration reference:
Press [N/-] to advance. You will see this screen:
Do not begin sampling yet! Before you start sampling, you must insert a RAE-Sep
separation tube into the inlet/holder. Follow the Separation tube preparation and
placing a tube into the UltraRAE 3000+ instructions before pressing any buttons on
the UltraRAE 3000+. Once the tube is in place, then proceed to measuring.
Once a tube's ends are broken off, the material inside is exposed. Therefore, use the tube for
sampling as soon as possible. It is recommended to use within 15 minutes.
Handheld PID Monitors
WARNING
IMPORTANT!
41
User Manual