Lexus NX 300h 2020 Owner's Manual page 93

Vehicle sway warning
■
Detects the sway of the vehicle within a
lane, which is often associated with a
decrease in the driver's attention level,
and displays the decrease in attention
using a bar display.
The shorter the bar length, the more
the driver may need to rest.
This display is a part of the LTA (Lane
Tracing Assist) system or LDA (Lane
Departure Alert with steering control)
system. The display is enabled when
the operating conditions of the vehicle
sway warning are met. (P.221, 230)
Display off
■
A blank screen is displayed.
Tire inflation pressure
■
● It may take a few minutes to display the
tire inflation pressure after the power
switch is turned to ON mode. It may also
take a few minutes to display the tire infla-
tion pressure after inflation pressure has
been adjusted.
● "--" may be displayed if the tire informa-
tion cannot be determined due to unfa-
vorable radio wave conditions.
Tire inflation pressure changes with tem-
●
perature. The displayed values may also
be different from the values measured
using a tire pressure gauge.
■ When disconnecting and reconnecting
12-volt battery terminals
The drive information will be reset.
Navigation system-linked dis-
play (if equipped)
Select to display the following naviga-
tion system-linked information.
 Route guidance
2-1. Instrument cluster
 Compass display (heading-up dis-
play)
Audio system-linked display
Select to enable selection of an audio
source or track on the display using the
meter control switches.
Driving assist system information
Select to display the operational status
of the following systems:
 LTA (Lane Tracing Assist) (P.217)
 LDA (Lane Departure Alert with
steering control) (P.226)
 Dynamic radar cruise control with
full-speed range (P.236)
 RSA (Road Sign Assist) (P. 234)
The displayed icon changes depending
on the system used.
Warning message display
Select to display warning messages
and measures to be taken if a malfunc-
tion is detected. (P.396)
Settings display
The settings of the following items can
be changed using the meter control
switches.
For functions that can be enabled or
disabled, the function switches
between on and off each time
pressed.
91
2
is