not performed even with the portable
device placed on the charge area, remove
the cover and accessories.
While charging, noise enters the AM
■
radio
Turn off the wireless charger and confirm
that the noise has decreased. If the noise
decreases, continuously pushing the power
supply switch of the wireless charger for 2
seconds, the frequency of the charger can
be changed and the noise can be reduced.
Also, on that occasion, the operation indi-
cator light will flash orange 2 times.
Important points of the wireless charger
■
If the electronic key cannot be detected
●
within the vehicle interior, charging can-
not be done. When the door is opened
and closed, charging may be temporarily
suspended.
When charging, the wireless charging
●
device and portable device will get
warmer, however this is not a malfunction.
5-5. Using the other interior features
When a portable device gets warm while
charging, charging may stop due to the
protection function on the portable
device side. In this case, when the tem-
perature of the portable device drops
significantly, charge again.
■
Operation sounds
When the power supply is turned on, while
searching for the portable device a sound
will be produced, however this is not a mal-
function.
Certification for the wireless charger
■
FCC Note: This equipment has been tested
and found to comply with Part 18 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential installa-
tion.
FCC Caution: Any changes or modifica-
tions not expressly approved by the party
responsible for compliance could void the
user's authority to operate this equipment.
315
5