Lexus NX 300h 2020 Owner's Manual page 250

248
4-5. Using the driving support systems
enabled/disabled on the multi-informa-
tion display as following:
1 Press or
switches and select
2
Press or
switches and select "PKSA".
3
Press or
switches, select
to select the desired setting
(on/off).
When ON (enable) is selected, the
Intuitive parking assist indicator comes
on.
When switched to OFF (disable) and
the Intuitive parking assist is deacti-
vated, the system will not reactivate if it
is not switched to ON again from the
screen of the multi-information dis-
play (Will not reactivate via power
switch operations).
■ The intuitive parking assist can be oper-
ated when
The power switch is in ON mode.
●
● Intuitive parking assist function is on.
The vehicle speed is less than about 6
●
mph (10 km/h).
of meter control
.
of meter control
of meter control
, and then press
● A shift position other than P is selected.
Setting the buzzer volume
■
The buzzer volume can be adjusted on the
multi-information display. (P.246)
■ Muting the buzzer sound
To mute the buzzer sound
●
The buzzer can be temporarily muted by
pressing of the meter control
switches while an obstacle detection dis-
play is shown on the multi-information
display.
To cancel the mute
●
Mute will be automatically canceled in
the following situations.
• When the shift position is changed
• When the vehicle speed has reached or
exceeded approximately 6 mph (10
km/h) with the shift lever in D
• When the intuitive parking assist is turned
off once and turned on again
• When the power switch is turned off once
and turned to ON mode again
• When a sensor is malfunctioning
Intuitive parking assist display
■
When an obstacle is detected while the
Lexus parking assist monitor is in use, the
warning indicator will appear in the upper
corner of the screen even if the display set-
ting has been set to off.
If "Parking Assist Unavailable" or "Park-
■
ing Assist Unavailable Clean Parking
Assist Sensor" is displayed on the multi-
information display
A sensor may be dirty or covered with snow
or ice. In such cases, if it is removed from
the sensor, the system should return to nor-
mal.
Also, due to the sensor being frozen at low
temperatures, a malfunction display may
appear or an obstacle may not be detected.
If the sensor thaws out, the system should
return to normal.
■ If "Parking Assist Malfunction Visit Your
Dealer" is displayed on the multi-infor-
mation display
Depending on the malfunction of the sen-
sor, the device may not be working nor-
mally. Have the vehicle inspected by your