Lexus NX 300h 2020 Owner's Manual page 153

Tilting up and down
■
1
Tilt up
Press and hold the "UP" switch. It automat-
ically opens until the tilt up stop position.
2
Tilt down
Press and hold the "DOWN" switch. The
moon roof full close automatically.
*
: Lightly press either end of the moon roof
switch to stop the moon roof while it is
operating.
The moon roof can be operated when
■
The power switch is in ON mode.
Jam protection function
■
If an object is detected between the moon
roof and the frame while the moon roof is
closing or tilting down, travel is stopped and
the moon roof opens slightly.
Sunshade
■
The sunshade can be opened and closed
manually. However, the sunshade will open
automatically when the moon roof is
opened.
■ When the moon roof does not close nor-
mally
Perform the following procedure:
● If the moon roof closes but then re-opens
slightly
1 Stop the vehicle.
2 Press and hold the "CLOSE" switch.
The moon roof will close, reopen and pause
for approximately 10 seconds.
Then it will close again and tilt down. Finally
3-5. Opening, closing the windows and moon roof
it will stop.
3
●
1
2
The moon roof will close, reopen and pause
for approximately 10 seconds in the tilt up
position.
Then it will close again. Finally it will stop.
3
*
*1
: If the switch is released at the incorrect
*
*2
If the moon roof does not fully close even
after performing the above procedure cor-
rectly, have the vehicle inspected by your
Lexus dealer.
■
When the opening and closing operation or
automatic opening function of the moon
roof does not move normally, perform the
following initialization procedures.
1
2
The initialization method changes depend-
ing on the contents that can be operated.
●
*1
3
*2
Open until the tilt up stop position. After
that the moon roof opens and completely
Check to make sure that the moon roof
completely stops and then release the
switch.
If the moon roof tilts down but then tilts
back up
Stop the vehicle.
Press and hold the "DOWN" switch.
*2
Check to make sure that the moon roof
has completely stopped and then
release the switch.
time, the procedure will have to be per-
formed again from the beginning.
: If the switch is released after the above
mentioned 10 second pause, automatic
operation will be disabled. In that case,
perform the moon roof initialization by
referring to "When tilt up/down or moon
roof opening and closing can be done
but automatic full opening and closing
cannot be done" on P.151.
When the moon roof does not move
normally
Turn the power switch to ON mode.
Operate the moon roof.
If only the tilt up operations can be done
when the moon roof is closed
Press and hold the "DOWN" or
"CLOSE" switch.
151
*1
3