Lexus NX 300h 2020 Owner's Manual page 123

● When the vehicle is parked in a place
where objects such as plants are near the
rear bumper
● If luggage, etc. is set near the rear
bumper
If accessories or a vehicle cover is
●
installed/removed near the rear bumper
● When the vehicle is being towed
To prevent unintentional operation, turn the
kick sensor operation setting off.
When reconnecting the 12-volt battery
■
To enable the power back door to operate
properly, close the back door manually.
Jam protection function
■
Sensors are installed in the right and left
sides of the power back door. When the
door is automatically closing and the sen-
sors are pushed due to an object being
clamped, etc., the jam protection function
operates.
From that position the door automatically
moves a little in the opposite direction and
then the function stops.
If the back door opener is inoperative
■
The back door can be unlocked from the
inside.
1 Remove the cover.
To protect the cover, place a rag between
the flathead screwdriver and the cover as
shown in the illustration.
3-2. Opening, closing and locking the doors
2
Move the lever.
Customization
■
Settings (e.g. back door automatic open
and stop position) can be changed. (Cus-
tomizable features: P.441)
Back door closer
■
In the event that the back door is left
●
slightly open, the back door closer will
automatically close it to the fully closed
position. It takes several seconds
before the back door closer begins to
operate. Be careful not to catch fingers
or anything else in the back door, as
this may cause bone fractures or other
serious injuries.
Use caution when using the back door
●
closer as it still operates when the
power back door system is canceled.
WARNING
121
3