Lexus NX 300h 2020 Owner's Manual page 141

will be overwritten.
Seat positions that can be memorized
■
(P.132)
The adjusted positions other than the posi-
tion adjusted by lumbar support switch can
be recorded.
■ In order to correctly use the driving
position memory function
If a seat position is already in the furthest
possible position and the seat is operated in
the same direction, the recorded position
may be slightly different when it is recalled.
WARNING
■ Seat adjustment caution
Take care during seat adjustment so that
the seat does not strike the rear passen-
ger or squeeze your body against the
steering wheel.
Recalling a driving position
1
Check that the shift lever is in P.
2
Turn the power switch to ON
mode.
3-3. Adjusting the seats
3
Press one of the buttons for the
driving position you want to recall
until the buzzer sounds.
To stop the position recall operation
■
part-way through
Perform any of the following:
Press the "SET" button.
●
Press button "1", "2" or "3".
●
Operate any of the seat adjustment
●
switches (only cancels seat position
recall).
● Operate the tilt and telescopic steering
control switch (only cancels steering
wheel position recall).
Operating the driving position memory
■
after turning the power switch off
Recorded seat positions can be activated
up to 180 seconds after the driver's door is
opened and another 60 seconds after it is
closed again.
Registering/canceling/recall a
driving position to an electronic
key (memory recall function)
Registering procedure
■
Record your driving position to button
"1", "2" or "3" before performing the
following:
Carry only the key you want to register,
and then close the driver's door.
If 2 or more keys are in the vehicle, the
139
3