Lcd Panel Configuration - SATO e Series Service Manual

2.3 LCD Panel Configuration

The LCD Panel is used in conjunction with the LINE and FEED switches to manually
enter printer configuration settings. Many of the settings can also be controlled via
software commands and in the case of conflict between software and control panel
settings, the printer will always use the last valid setting. If you load a label job that
includes software settings and then enter a new setting via the LCD Panel, the manually
set values will be used by the printer. If you set the values manually and then download
a job with software settings, the software settings will be used.
There are 10 modes of operation you can access from the LCD panel. To enter the
desired mode, the KEY SEQUENCE combination listed in the table must be
performed. The initial LCD display message is shown for each mode.
MODE
Normal
Conventional/
Interchangeable
Advanced
Test Print
Default Setting
Maintenance
Non Standard Clear
Protocol Code
Download
Hex Dump
Firmware
Download
KEY SEQUENCE
POWER
DSW2-8 ON + POWER
LINE + POWER
FEED + POWER
LINE + FEED + POWER
LINE + FEED + DSW2-4 ON +
POWER
LINE + FEED + DSW2-7 ON +
POWER
LINE + DSW2-7 ON +
POWER
DSW2-4 ON + POWER
DSW2-6 ON + POWER
SATO M-10e TT/DT Printers Service Manual
Section 2. Configuration
INITIAL DISPLAY
ONLINE
QTY:000000
ONLINE
QTY:000000
ADVANCED MODE
TEST PRINT MODE
CONFIGURATION
DEFAULT SETTING
YES NO
MAINTENANCE MODE
DSW2-4 ON>OFF
ALTPROTOCOL
USERDOWNLOAD
ONLINE
QTY:000000
FLASH DOWNLOAD
READY
PAGE
2-10
2-13
2-34
2-35
2-36
2-38
2-39
2-40
2-41
PN 9001098
Rev. A
2-9