Replacing The Eeprom - SATO e Series Service Manual

6.13 Replacing the EEPROM

STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cord.
2. Unfasten (5) screws from the left side cover and remove.
3. Remove the Item 3 EEPROM chip at location shown in illustration below.
4. Install the new EEPROM chip being careful to properly align the chip, using the
"U" shaped notch as a reference. Be careful not to bend any of the EEPROM legs
and that it is set securely in the socket.
5. Replace the left side cover.
6. Complete the Factory Reset Procedure.
NOTCH OUTLINE
ALIGN NOTCHES
SATO M-10e TT/DT Printers Service Manual
Section 6. Replacement Procedures
ON BOARD
EEPROM CHIP
PN 9001098
Rev. A
6-19