SATO e Series Service Manual page 38

Section 2. Configuration
LCD Panel —Advanced Mode
Zero Slash
This setting determines if a zero is printed with a slash or without a slash. This setting can also
be controlled via software commands. When YES is selected, the printer internal fonts will have
a slash through the center of the zero character.
STEP
1.
2.
Auto Online
This setting determines the mode in which the printer powers up. If YES is selected, the
printer powers up in the ONLINE Mode and is ready to print. If NO is selected, the printer
powers up in the OFFLINE Mode and must be manually placed in the ONLINE Mode by
pressing the ENTER key before it is ready to print.
STEP
1.
2.
Print Offset
Since the printer move the label in discrete steps equal to the size of the print dot, the units of
measure for Vertical and Horizontal Offset distance is dots.
Vertical Offset is the distance down from the leading edge in dots (the edge of the label that
comes out of the printer first) to the first vertical print position. A positive setting moves the
label edge out of the printer while making it negative moves it back into the printer. The
maximum value that can be set is 3600 dots.
PN 9001098
Rev. A
2-14
zero slash
Yes No
PROCEDURE
Use the
Once the correct setting is selected, press ENTER to accept the setting
and advance to the Auto Online display.
auto online
Yes No
PROCEDURE
Use the keys to step the cursor to either YES or NO.
Once the correct setting is selected, press ENTER to accept the setting
and advance to the Print Offset display.
print offset
v:+0000 h:+0000
SATO M-10e TT/DT Printers Service Manual
keys to step the cursor to either YES or NO.