Lcd Panel Printer Configuration - SATO CL608e Operator's Manual

Cl series "e" thermal transfer printers
Hide thumbs Also See for CL608e:
Table of Contents

Advertisement

LCD PANEL PRINTER CONFIGURATION

The LCD Panel is used by the operator in conjunction with the LINE and FEED
switches to manually enter printer configuration settings. Many of these settings can
also be controlled via software commands and in the case of conflict between
software and control panel settings, the printer will always use the last valid setting.
If you load a label job that includes software settings and then enter a new setting via
the LCD panel, the manually set values will be used by the printer. If you set the
values manually and then download a job with software settings, the software
settings will be used.
There are nine modes of operation. To enter the desired mode, the KEY SEQUENCE
combination listed in the table below must be performed. The initial LCD display
message is shown for each mode.
MODE
Normal
Advanced
Test Print
Default Setting
Clear Non-Standard Protocol
Protocol Code Download
Hex Dump
SATO CL Series "e" Printers
KEY SEQUENCE
POWER
LINE + POWER
FEED + POWER
LINE + FEED + POWER
DSW2-7 ON + LINE + FEED
+ POWER
DSW2-7 ON + POWER
DSW2-4 ON + POWER
PN 9001074 Rev. B
Section 3. Configuration
INITIAL DISPLAY
ONLINE
QTY:000000
ADVANCED MODE
TEST PRINT MODE
CONFIGURATION
DEFAULT SETTING
YES
NO
ALT. PROTOCOL
USER DOWNLOAD
ONLINE
QTY:000000
PAGE
3-10
3-12
3-22
3-23
3-24
3-24
3-25
Page 3-9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cl612eCl408eCl412eCl e series

Table of Contents