SATO e Series Service Manual page 59

LCD Panel — Test Print Mode
Test Print Size
10 CM
This selection sets the paper size for a test print. (Not displayed when MEMORY is selected.)
Default value is the maximum horizontal size (cm).
STEP
1.
2.
LCD Panel — Default Setting Mode
Occassionally it is desirable to reset all printer configuration settings to their original default
conditions. This allows the operator to start the reconfiguration of the printer starting from a
known set of conditions.
Default Setting Mode
STEP
1.
2.
3.
test print size
10 CM
PROCEDURE
Press the LINE and FEED keys simultaneously. This selects the test print size
(13~ Maximum horizontal size).
Press ENTER to confirm the test print size. After selecting test print paper size,
test print will start. During printing, when the ENTER key is pressed, the test
printing will be suspended. Press the ENTER key again to restart test printing.
Pressing the ENTER key again suspends/restarts test printing.
To exit the Test Print Mode, power off the printer, then back on.
default setting
PROCEDURE
Power on the printer while pressing the LINE and FEED keys
simultaneously. When the printer emits one long beep release the keys.
Use the
Default).
Press the ENTER key to confirm your selection.
SATO M-10e TT/DT Printers Service Manual
NOTE: This display does not
appear when a Memory Test
Print is chosen. Only a small
Memory Print can be printed.
press enter key to
stop printing
yes no
keys to select either YES (Default) or NO (Do not
Section 2. Configuration
PN 9001098
Rev. A
2-35