Replacing The Pitch Sensor (Sen2 Pcb) (Gap Sensor) - SATO e Series Service Manual

6.15a Replacing the Pitch Sensor (SEN2 PCB) (Gap Sensor)
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cord.
2. Raise the Access Cover.
3. Unload the ribbon and label stock. (NA for ribbon on Direct Thermal units).
4. Remove (1) Item 1 screw to detach Item 3 Sensor Cover from SEN2 PCB.
5. Detach (1) Item 2 connector from Item 4 SEN2 PCB.
6. Remove and replace SEN2 PCB.
7. Replace the Sensor Cover.
8. Refer to Section 4.6 "Adjustment of Gap Sensor".
REMOVE ITEM 1
SCREW TO DETACH
ITEM 3 SENSOR
COVER FROM ITEM 4
SEN2 PCB
DETACH ITEM 2
CONNECTOR
SATO M-10e TT/DT Printers Service Manual
Section 6. Replacement Procedures
SEN2
PN 9001098
Rev. A
6-21