Section 4. Electrial Checks and Adjustments
4.2 Steps Prior to Some Procedures
Some procedures in this section require access to potentiometers and the test point
connector located on the main circuit board. Raise the Access Cover and detach the left
side cover for accessing the main circuit board.
STEP
PROCEDURE
1.
Switch the printer OFF and disconnect the power cord.
2.
Raise and remove the Access Cover.
3.
Unfasten (5) screws from the left side cover and remove.
LEFT SIDE
COVER
LEFT SIDE
COVER
PN 900109
Rev. A
4-2
SATO M-10e TT/DT Printers Service Manual
ACCESS COVER