Lcd Panel Printer Configuration - SATO M-84PRO Operator's Manual

Section 3. Configuration

LCD PANEL PRINTER CONFIGURATION

The LCD Panel is used by the operator in conjunction with the LINE and FEED switches to
manually enter printer configuration settings. Many of these settings can also be controlled via
software commands and in the case of conflict between software and control panel settings,
the printer will always use the last valid setting. If you load a label job that includes software
settings and then enter a new setting via the LCD panel, the manually set values will be used
by the printer. If you set the values manually and then download a job with software settings,
the software settings will be used.
There are seven modes of operation. To enter the desired mode, the KEY SEQUENCE
combination listed in the table below must be performed. The initial LCD display message is
shown for each mode.
MODE
Normal
Advanced
Test Print
Default Setting
Clear Non-Standard
Protocol
Protocol Code
Download
Hex Dump
NORMAL MODE
The printer initially powers on in the ONLINE mode. The user can access the User Settings
using the following procedures.
V 05.00.03.00
INITIALIZING
ONLINE
QTY:000000
Page 3-10
KEY SEQUENCE
POWER
LINE + POWER
FEED + POWER
LINE + FEED + POWER
DSW2-7 ON + LINE +
FEED+ POWER
DSW2-7 ON + POWER +
LINE
DSW2-4 ON + POWER
Displays the firmware during the initialization.
The LCD will display the ONLINE status on the top line and the
bottom line will contain the label quantity (QTY) status. The
messsge will be changed to OFFLINE whenever the printer is
switched offline by pressing the LINE key. As soon a print job is
received, the quantily line will indicate the number of labels to be
printed. As soon as the label job begins to print, the display will
indicate the number of labels in the print job that remains to be
printed.
PN 9001105 Rev. A
INITIAL DISPLAY
ONLINE
QTY:000000
ADVANCED MODE
TEST PRINT MODE
CONFIGURATION
DEFAULT SETTING
YES NO
ALT. PROTOCOL
USER DOWNLOAD
ONLINE
QTY:000000
SATO M-84PRO
PAGE
3-10
3-13
3-25
3-26
3-27
3-27
3-28