SATO e Series Service Manual page 43

LCD Panel — Card Mode
copy start
yes No
STEP
4.
5.
truetype fontcopy
completed
Card -> MemoryCopy
SATOFont Y/N
This selection allows you to copy SATO fonts from the PCMCIA Memory card installed in
the Memory Card slot on the rear of the printer to the optional Flash ROM.
STEP
1.
2.
3.
copy start
yes
PROCEDURE
Once the copy process is completed, press the ENTER key to step the display.
If an error is encountered in the copy process, one of the following messages
will be displayed on the second line.
R/W Indicates a Read/Write error occured.
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory available.
card -> memorycopy
satofont y/n
PROCEDURE
Use the
If Yes is selected, the printer will enter the Card Copy mode. If No is
selected, the display will advance to the Card to Memory Copy All mode.
Confirm your selection by stepping the cursor to the Yes selection. If you
selected No, the display will return to the previous selection.
Press the ENTER key to accept the selection. If Yes was selected, the copy
process will start.
No
SATO M-10e TT/DT Printers Service Manual
truetype fontcopy
copying
cardcopy/format
xxxxxxx error
keys to step the cursor to either YES copy or NO.
satofontcopy
copying
Section 2. Configuration
PN 9001098
Rev. A
2-19