Configuration - AGFA CR 30-X User Manual

CR 30-X

Configuration

The CR 30-X is always dedicated to a single workstation, on which the
identification software as well as the image processing software is running.
The identification data are transmitted from the workstation to the digitizer
via FireWire. For more information, refer to the workstation's On-line Help
manuals or contact your local service organization.
Dedicated configuration
For more information, refer also to the CR 30-X System User Manual,
document 2385.
10
Introduction
Caution: The CR 30-X must not be connected to any version of the Agfa
ADC QS or ADC VIPS software.
CR 30-X
Control PC
2386B EN 20060926