Table of Contents
Advertisement
DD+DIS303.03E
9
9.1
9.2
Edition 6, Revision 0
Technical Data
Electrical data
Power connection
Power consumption:
Standby
(room temperature ~ 20 °C)
during film processing
Fuse protection
Leakage current towards PE
Main breaker
Safety regulations
Ambient and climatic conditions
Room temperature
Relative humidity
Ventilation
Light-tightness
Acoustic test
ISO 7779
(airborne noise)
Classic E.O.S. / Classic E.O.S. CL
(Type 5270 / 100 / 105)
1N~ 230 – 240 V; 50/60 Hz (200 - 240 V)
0.45 kWh (1620 kJ)
2.9 kW/h (10440 kJ/h)
15 A / 16 A
< 3.5 mA
Upon machine installation it must be
ensured that either the mains
connector or an all-pole circuit
breaker for the installation on site is
located close to the machine and
easily accessible.
Electrical installations in the installation
room must be incompliance with IEC 364
(VDE 0100 / 0107).
A GFI switch: (I
compliance with VDE 664) is
integrated in the machine.
min. 10 °C (50 °F), max. 30 °C (86 °F)
Room temperature min. 5 °C (41 °F) below the set
developer temperature
min. 10 %, max. 80 %, no condensation
Avoid inhaling of chemical fumes. Make sure that
there is sufficient ventilation at the installation site
of the machine, i.e. an air exchange that is at
least ten times the room volume per hour.
maximum 2500 Lux
The machine must not be opened
during the operation. It is light tight
only if all panels are correctly
mounted.
during standby
during film cycle
Installation Planning
= 30 mA in
N
max. 35 dB (A)
max. 48 dB (A)
Chapter 14 / 33
Advertisement
Table of Contents
