Sanyo VCC-XZN600P Instruction Manual page 4

Be sure to turn OFF the power switch of all devices to be connected.
In addition, read the instruction manual for each device carefully so that you can connect devices correctly. Note
that incorrect connection may cause smoke or malfunction.
1
Connect the video cable.
Use the coaxial cable to connect the camera's video output (VIDEO OUT) connector to the video input (VIDEO
IN) connector of your monitor or other peripheral device.
Cable type RG-59U (3C-2V), 250 m maximum
Cable type RG-6U (5C-2V), 500 m maximum
Cable type RG-11U (7C-2V), 600 m maximum
Using lower-grade cables will cause the attenuation of the video and synchronization signals,
preventing correct transmission.
An RG-59U coaxial cable may be used if the distance between devices you want to connect is short.
However, avoid using it for piping or air wiring.
Use CCTV/Video-compatible coaxial cables.
2
Connect the power cables to the power terminals of the one-touch connector.
Use a power cable with an AWG wire (20, 21 or 22).
Although power wires have no polarity in this case, the earth wire must be connected to the earth (COMMON)
terminal.
4 / 153