Sanyo VCC-XZN600P Instruction Manual page 135

When you access the camera through the UPnP connection, make sure that the [UPnP] option is set to
"ON" (factory setting value).
When you access the camera through the UPnP connection, enable the UPnP component on your
PC.
After you change the [UPnP] settings, use the Close button to terminate the camera connection and
access the camera again.
After you change the [UPnP] setting from "ON" to "OFF", take a note of the camera's IP address
shown in the [NETWORK SETTINGS] screen so that you can access the camera from the Web
browser.
You can update the option board firmware to the latest version.
Click the [SET] button to display the [FIRMWARE UPDATE] screen.
Click the [Browse...] button to locate the firmware update file, and click the [EXECUTE] button.
This starts the firmware update process.
Neither make any operations on the screen nor turn power off while the "LOADING FIRMWARE
FILE..." message is displayed.
You cannot update the firmware while recording a video. Trying to update the firmware during
recording causes the operation confirmation dialog to appear.
Every function is suspended and unavailable while the firmware is being updated.
135 / 153