Sanyo VCC-XZ200P Installation Manual

English Français Deutsch
INSTALLATION MANUAL
Color CCD Camera
☞ Please read this manual before installing and using this camera, and always follow the instructions in it for
proper use.
• Check that the installation location is strong enough to bear the camera before proceeding.
• Install in a location (such as underneath overhangs) that is not exposed to direct sunlight.
• Install to a wall or ceiling with no unevenness in its surface.
If installing to a curved surface, round pillar or similar, use a special bracket (separately ordered).
Accessories
Hexagonal wrench,
Large and Small . . . . . . . . . . . . . . . each 1
One-touch connector
(attached to connection cord). . . . . . . . . 1
Fixer
(for securing drop-prevention chain) . . . 1
Desiccant . . . . . . . . . . . . . . . . . . . . . . . . 1
Foil pouch
1
Setup
1 Install the camera to the wall or ceiling.
If routing the connection cord outside the wall, install so that
the connection cord hole is facing downward, and pull the
connection cord out from the hole.
Be sure to embed the mounting screws at least 3 cm into
the wall. If the screw holes are too shallow, the camera
mount may fall down.
Mounting screw: M8
Printed on recycled paper
1AC6P1P3050--
L5BJ2/XE (0306KP-SY)
中文简体
Connection cord hole
Sunshade . . . . . . . . . . . . . . . . . . . . . . . . 1
Sunshade mounting screws
(Self-tapping type) . . . . . . . . . . . . . . . . . 2
Sunshade mounting bracket. . . . . . . . . . 1
Sunshade mounting bracket screws. . . . 2
2 Adjust the position of the camera.
Use the hexagonal wrench (large, accessory) to loosen the
screws at the place that you want to move, and then adjust
the direction of the camera.
After making the adjustment, securely re-tighten the screws.
Maximum 90 degrees
(to prevent cord from twisting)
Screw tightening torque after adjustment:
2 N . m or more
Screw tightening torque after adjustment:
4.3 N . m or more
VCC-XZ200P
Printed in Japan