Sanyo VCC-XZN600P Instruction Manual page 2

Shape Color
One-touch RED
1
connector
WHITE
Individual ORANGE
2
cables
YELLOW
GRAY/BLACK
BLACK
BLUE
LAN cable BLACK (thick)
3
connector
–
BROWN/BLACK POE (–48V)
GREEN
SKYBLUE
PINK
ORANGE/BLACK TX (–)
GRAY
BNC COAXIAL CABLE VIDEO OUT
4
connector
For the cable type, see the "cable label" attached to the cable bundle.
Follow the steps below to connect each cable firmly to the one-touch connector.
Signal Name Use
24 VAC/12 Used to connect the power supply.
VDC (+)
24 VAC/12
VDC (–)
ZOOM Used to adjust the camera zoom by external voltage control.
DC ± (6 to 12 V), +: WIDE/-: TELE
FOCUS Used to adjust the camera focus by external voltage control.
DC ± (6 to 12 V), +: FAR/-: NEAR
ALARM IN 1 Used to connect alarm switch, infrared sensor, or other external devices.
To automatically switch between the color and black/white modes, select
[DAY/NIGHT], choose the "COLOR" mode, and then set the "EXT ALARM" to
ALARM IN 2
an appropriate input level.
ALARM OUT Used to connect a buzzer, lamp, video recorder, or other peripheral device.
To control the alarm output externally from a remote location, on the ALARM
OUT screen, select [OUTPUT] and choose "REMOTE.".
COMMON Used to connect the LAN cable to enable network operations.
N.C
POE (0V)
RX (–)
RX (+)
TX (+)
Used to connect to the VIDEO IN connector of your monitor.
2 / 153