Connecting The Power Optimization System - Henny Penny FlexFusion FSEN605 Installation Manual

Connecting the unit

6.2.2 Connecting the power optimization system

DANGER
DANGER
Prerequisite Unit dead
30
4. Secure the connection line with cable ties.
5. Connect connection cable in accordance with the circuit diagram.
6. Tighten threaded cable connection to provide strain relief.
7. Close the housing (see "Opening and closing the housing").
8. Complete the start-up operation report.
Risk of personal injury and property damage from electric shock
• Before working on the unit, ensure that the unit has been disconnected from
the power supply.
Risk of personal injury and property damage from electric shock
• Before connecting, ensure that the electrical connection line is dead.
• Ensure that the electrical connection line is undamaged.
The unit can be connected to a power optimization system designed to
DIN 18875 with a potential-free contact. The potential-free contact is
used to link the unit to the control. The required cable length in the unit
for the power optimization system corresponds to the height of the unit.
Image: Connecting the power optimization system
a Connection terminals X2 for power
optimization system
b Cable tie
c Electrical connection line
Connection line dead
Unit cover open
Back wall open
1. Press out appropriate opening in the bottom.
2. Screw in appropriate threaded cable connection.
Installation instructions
a
b
c
d
e
d Connection line for power
optimization system
e Cable entry