Henny Penny FlexFusion FSEN605 Installation Manual page 21

c
1
b
Image: Arrangement of the floor plates (view from above)
a Cooking chamber door
b Unit leg or underframe
To prevent the unit from tilting, a special fastening kit is supplied by the
manufacturer or is available as an accessory.
The fastening kit contains two floor fasteners and all components
required to bolt or bond to the floor.
The unit or underframe is fastened by means of two floor fasteners as
shown in the drawing.
Floor without steam barrier
In the case of floors without a steam barrier, the floor plates are bolted
to the floor using the bolts provided.
a
A
e
d
Image: A: Position of floor plate; B: floor plate bolted to the floor
a Cap nut
b Holding plate
c Upright bolt
Installation instructions
2
a
c Floor plates
B
f
b
c
d Floor plate
e Lag bolt
f Unit leg
Installing the unit
1
2
21