Installation; Installation Environment; Installation Space - Oki ES6450 User Manual

Installation

Installation environment

Install this machine in the following environment.
Ambient temperature: 10°C to 32°C
Ambient humidity: 20% to 80% RH (relative humidity)
Maximum wet-bulb temperature: 25°C
 Make sure there is no condensation. Failure to do so may cause a malfunction.
 To install this machine in a location where the ambient humidity is 30% RH or less, use a humidifier or static
prevention mat.
 Depending on the installation environment, the operating noise of this machine may cause concern. If you are
concerned about the operating noise, we recommend that you install this machine in an isolated location or a separate
room.
 Do not install this machine near any devices in which combustion takes place. Doing so may cause lighter printing.
 Do not install this machine close to high-temperature locations or naked flames.
 Do not install in locations where chemical reactions occur (e.g. laboratories).
 Do not install this machine close to combustible solutions such as alcohol and thinners.
 Do not install this machine within the reach of children or infants.
 Do not install this machine in an unstable location (e.g. unsteady table or sloping surface).
 Do not install this machine in a humid or dusty location, or in a location exposed to direct sunlight.
 Do not install this machine in an environment with salt air, corrosive gas, NOx, or SOx.
 Do not install this machine in locations with major vibration.
 Do not install this machine in locations where its air vents are blocked.
 Do not directly install this machine on shaggy rugs or carpets.
 Do not install this machine in locations with poor air circulation or ventilation like in a sealed room.
 Ensure proper ventilation when it is used for a long time in a small room.
 Keep this machine away from strong magnetic fields and sources of noise.
 Keep this machine away from monitors and TVs.
 When moving this machine, stand at the front and back and hold the handle at the bottom of the machine.

Installation space

Install this machine on a flat desk which is larger than the bottom of the machine.
Allow sufficient space around this machine as shown in the following figures.
 Plan view (When the optional caster stand is not installed)
Connecting to the PC after preparing this machine
- 16 -