Oki ES6450 User Manual page 119

Wired(LAN1)
Setup
USB Setup USB
Speed
Soft Reset
Serial Number
Offline Receive
USB Memory Interface
Connected Host
Print Setup Personality
Copies
Duplex
Binding
Media Check
Item
Network Scale
Network Factory Defaults
Wired(LAN1)
IP Address Set
IPv4 Address
Subnet Mask
Gateway Address
DHCPv6
HUB Link Setting
Changing settings from the operator panel
Factory
default
settings
Small Normally, [Small] is selected.
Execute Restores network menu settings to factory
default settings.
Enable Enables/Disables the wired LAN1.
Auto Set to obtain the IPv4 address automatically
or input it manually.
xxx.xxx.xxx.x Input the IPv4 address manually. Displayed
xx when [IP Address Set] is set to [Manual].
xxx.xxx.xxx.x Input the subnet mask. Displayed when [IP
xx Address Set] is set to [Manual].
xxx.xxx.xxx.x Input the gateway address. Displayed when
xx [IP Address Set] is set to [Manual].
Disable Set to obtain the IPv6 address automatically.
Set to [Disable] when you do not use the
IPv6 address.
Auto Sets the connection method to the hub.
Negotiate
Enable Enables/Disables the USB interface.
480 Mbps Sets the maximum baud rate using a USB
interface.
Disable Enables/Disables the soft reset command.
Enable Enables/Disables the USB serial number.
The USB serial number is used to identify
the USB device connected to the PC.
Disable When [Enable] is selected, data can be
received even if the printer is offline.
Enable Enables/Disables the USB memory
interface.
Normal Set to [Specific] in case of timeout when
printing is done on this machine which is in
the sleep mode.
Power consumption in the sleep mode is
higher than the state where it is set to
[Normal].
Auto Selects the operating language of the
printer.
1 Sets the number of copies.
The value set in the printer driver takes
priority.
On or Off Sets whether or not to implement duplex
*1
printing.
The value set in the printer driver takes
priority.
Long Edge Specifies the binding method for duplex
printing.
The value set in the printer driver takes
priority.
Enable Sets whether to check the mismatch
between the paper size of the print data and
that of the tray.
- 119 -
Description