Assembling Input Shaft/Checking And Adjusting End Float Of Spring Cluster - BMW R 1150 R Repair Manual

11
Assembling input shaft/checking and adjusting
end float of spring cluster
•
Lightly oil the bearing surface for constant-speed
gear (1) on input shaft (10), and install the con-
stant-speed gear.
•
Lightly oil the splines in thrust block (2) and install
it.
•
Place anti-rattle disc (3) on thrust block (2).
•
Mount spring cluster (4) with locating ring (arrow)
facing upwards on anti-rattle disc (3).
•
Install spacer (5).
•
Compress spring cluster (4) and insert the keep-
ers (6) in the ring groove.
•
Install retaining ring (7) with the shoulder facing
over keepers (6).
•
Check end float of spring cluster (4); correct if
necessary by installing spacer (5) of suitable
thickness.
1
3
10
4
R21230090
4
5
6
•
Check fully assembled length and adjust if nec-
essary ( 23.21).
a
•
Install spacing washer (8) of calculated thick-
ness, and press on grooved ball bearing (9).
End float:
Spring assembly on shaft ..................0.4 ... 0.6 mm
................................................ (0.0157...0.0236 in)
7
8
9
KR230081
23.15