3 Notes On Safety - Henny Penny FlexFusion FPG-221 Maintenance Instruction

3 Notes on safety
Organizational measures Risk of property damage and personal injury from lack of
Electrical connection Danger of electric shock from live components.
Gas connection Risk of explosion and fire from improper connection
The maintenance personnel must be familiar with regional regulations
and observe them.
The maintenance personnel must observe the safety information in
these maintenance instructions.
The maintenance personnel must also observe the "Safety
information" chapter in the installation instructions and operating
instructions of the unit.
organizational measures
• Inform the operators present prior to starting the maintenance
work.
• Discuss how to respond to an emergency prior to starting the
maintenance work.
• Use equipment and protective gear suitable for the activity.
• Prior to working on the electrical system, switch off the unit,
disconnect the electrical system from the mains and prevent
power from being switched on again. Check to ensure the system
is dead.
• Use only insulated tools.
• Do not put a unit with damaged operating elements into service.
• Observe applicable regional regulations of the gas utility.
• Ensure that only a tradesman licensed by the gas supplier
connects the unit to the gas supply.
• Prior to working on the gas system, switch off the unit, close the
gas supply from the gas system and secure it against being
reopened. When bleeding air or degassing, ensure that the air and
gas are discharged to the outside in a technically correct manner
and without creating a risk.
Observe the information on the nameplate and Gas type
•
additional shield.
• Check for leaks.
• When working on the gas system and units in buildings, ensure
that a hazardous gas-air mixture cannot form in the rooms.
Risk of poisoning from exhaust gases
• Ensure that exhaust gases are discharged properly and that the
necessary amount of combustion air is supplied.
Maintenance instructions
Notes on safety
7