Roland VersaEXPRESS RF-640 Service Notes page 132

Perform the following operations after replacement.
18
1. BATTERY INSTALLATION
Refer to [3-11 BATTERY REPLACEMENT].
2. FIRMWARE INSTALLATION
Refer to [4-2 HOW TO UPGRADE/INSTALL FIRMWARE].
3. SYSTEM PARAMETER INITIALIZE
Refer to [4-2 HOW TO UPGRADE/INSTALL FIRMWARE].
4. IP ADDRESS SETTING
Start the machine with the Service Mode and set in the User Menu.
5. PUT PARAMETER
Refer to [4-2 HOW TO UPGRADE/INSTALL FIRMWARE].
6. TIME AND DATE SETTING
Set the date and time in the [SERVICE MENU]>[SUB MENU]>[CLOCK].
*Set the [DATE] in order of the [Year/Month/Day].
7. SENSOR CHECK
It can be performed in the Sensor Check.
Perform the following operations if it is not possible to transfer the parameters by Peck6.exe.
1. BATTERY INSTALLATION
Refer to [3-11 BATTERY REPLACEMENT].
2. FIRMWARE INSTALLATION
Refer to [4-2 HOW TO UPGRADE/INSTALL FIRMWARE].
3. SYSTEM PARAMETER INITIALIZE
Refer to [4-2 HOW TO UPGRADE/INSTALL FIRMWARE].
4. TIME AND DATE SETTING
Set the date and time in the [SERVICE MENU]>[SUB MENU]>[CLOCK].
*Set the [DATE] in order of the [Year/Month/Day].
5. IP ADDRESS SETTING
Start the machine with the Service Mode and set in the User Menu.
6. HEAD RANK SETTING
It can be set in the [PRINT MENU]>[HEAD RANK].
7. SERIAL NUMBER INPUT
It can be set in the [SUB MENU]>[SERIAL NO.].
8. INK TYPE SETTING
It can be set in the [SUB MENU]>[CHANGE INKTYPE].
9. SENSOR CHECK
It can be performed in the Sensor Check.
10. LIMIT & CUT DOWN POSITION INITIALIZE
Refer to [4-4 LIMIT POSITION & CUT DOWN POSITION INITIALIZE]
11. FLUSHING POSITION ADJUSTMENT
Refer to [4-6 FLUSHING POSITION ADJUSTMENT].
* Perform the required adjustment depending on the serial number.
12. LINEAR ENCODER SETUP
Refer to [4-5 LINEAR ENCODER SETUP].
13. PAPER SIDE SENSOR ADJUSTMENT
14. HEAD ALIGNMENT
Refer to [4-3 HEAD ADJUSTMENT].
Only Bidirectional Adjustment is required.
15. CALIBRATION
Refer to [4-7 CALIBRATION].
3-58