Procedure - Precor StairClimbers Experience 800 line Series Service Manual

Procedure

Review entire procedure before starting.
Removal Instructions
1. Switch the power OFF and disconnect the power cord (slide the red release tab
reward to unlock).
2. Remove the following covers:
a. Top cover (see
b. Forward Upper/Lower Access covers (see
Covers Replacement" on page
c. Side Access Covers (see
d. Base cover (see
3. Disconnect the following cables from the back of the Input power switch assembly:
Disconnect the power cable brown and blue spade connectors:
l
Disconnect the green chassis ground wire spade connector.
l
4. Remove the two #3 Phillips screws and remove the Power Entry Switch Assembly
from the bracket. Retain part(s) and/or fastener(s) for installation.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
"Top Cover Replacement" on page
88)
"Side Access Covers Replacement" on page
"Base Cover Replacement" on page
6 Replacement Procedures
Power Entry Switch Assy Replacement
81)
"Upper and Lower Forward Access
95)
92)
Page 128