7. Select the printer, then click Next.
8. For Windows Me or 98, select LPT1 as the port the printer is
connected to, then click Next.
For Windows XP or 2000, go to the next step.
9. Follow the on-screen instructions for the rest of the
installation.
10. When installation is done, click Finish.
Installing the PostScript printer driver for the USB
interface
Follow the steps below to install the PostScript printer driver for
the USB interface.
Caution:
c
Never use EPSON Status Monitor and Postcript 3 driver at the
same time when the printer is connected via a USB port.
Note:
❏ For Windows Me or 98, if the Windows driver and the Adobe PS
driver for Epson printers with a USB connection have already been
installed on your computer, follow the installation procedure
"Installing the PostScript printer driver for the parallel interface"
on page 196, but make sure to select USB as the port in step 5. If
you have not installed an Epson USB printer driver on your
computer, follow the installation procedure below.
❏ Installing the printer software for Windows XP or 2000 may require
administrator privileges. If you have problems, ask your
administrator for more information.
❏ Turn off all virus protection programs before installing the printer
software.
198
Using the PostScript Printer Driver
N e w : i n c l u d i n g t h e i n f o r m a t i o n a b o u t W i n d o w s 9 5