If you select BarCode, the printer converts bit images to bar codes
by automatically filling in any vertical gaps between dots. This
produces unbroken vertical lines that can be read by a bar code
reader. This mode will reduce the size of the image being printed,
and may also cause some distortion when printing bit image
graphics.
ZeroChar
Selects whether the printer prints a slashed or unslashed zero.
CharacterSet
Selects character table 1 or 2.
Status and Error Messages
This section contains a list of error messages shown on the LCD
panel, giving a brief description of each message and suggestions
for correcting the problem. Note that not every message shown
on the LCD panel indicates a problem. When the
displayed at the right of the warning message, multiple warnings
occur. To confirm all warnings that occur, press the d Down
button to display the Status Menu, then press the
The LCD panel also displays the amounts of remaining toners and
available paper sizes.
Calibrating Printer
The printer automatically calibrates itself. This is not an error
message, and will clear itself after the calibration process has
finished. While the printer displays this message, do not open the
covers or turn off the printer.
Cancel All Print Job
248
Using the Control Panel
N e w : W i t h L C D p a n e l / c o n f i r m t h e p r o d u c t s p e c i f i c a t i o n a n d d e l e t e u n n e c e s s a r y i n f o r m a t i o n / u s e c a u t i o n w i t h t h e b u t t o n o r i c o n
mark is
Enter button.