Agilent Technologies 85110L User's And Service Manual page 101

Loading the System Configuration Disk
The 85108L system configuration disk contains files for pulsed-RF configuration and two
nonpulsed-RF configurations. Refer to
Table B-2 for 8510C revision C.07.xx to select the appropriate file for your system.
Table B-1 85108L System Configuration Disk Files - 8510C Firmware Revision
C.06.5x
File Name
MD_PULS
MD_NPULS
b
MD_SINGSRC
a. x denotes any digit as acceptable.
b. This configuration requires a single source, and a test set that provides an LO signal such
as the 8514, 8515, 8516, or 8517. Refer to Chapter 9, "System Installation," in the 8510C
On-Site Service Manual (part number 08510-90282) for a configuration diagram.
.
Table B-2 85108L System Configuration Disk Files - 8510C Firmware Revision
C.07.xx
File Name
MD_LOWPLS
MD_LOWNPLS
b
MD_SINGSRC
a. x denotes any digit as acceptable.
b. This configuration requires a single source, and a test set that provides an LO signal such
as the 8514, 8515, 8516, or 8517.
Procedure
1. Insert the 85108L system configuration disk into the disk drive of the network analyzer.
On the network analyzer, press
knob to select one of the files and press
2. Remove the disk when it has finished loading. Instrument State 8 (the power up state)
of the loaded file will be recalled automatically.
B-2
Table B-1
a
to C.06.99 (Part Number 85108-10007)
Source(s) Detectors and mode
Multiple Wide BW pulsed-RF mode
Multiple Normal BW nonpulsed-RF mode
Single Normal BW nonpulsed-RF mode
a
or higher (Part Number 85108-10008)
Source(s) Detectors and mode
Multiple Wide BW pulsed-RF mode
Multiple Normal BW nonpulsed-RF mode
Single Normal BW nonpulsed-RF mode
[TAPE/DISC] > LOAD > MORE > MACHINE DUMP
for 8510C firmware revision C.06.5x or
Description of Configuration
Description of Configuration
.
LOAD FILE
. Use the
Agilent 85110L Test Set