Nortel HMS400 Installation And Configuration Manual page 37

Note: If converting from Meridian Mail to HMS400, it is necessary to program another dummy
ACD number (NCFW to voicemail's Pilot DN) to be used as all MWK definitions on new phone
sets.
For the room status/minibar channel, the TN programming is essentially the same as the above.
The differences are:
TN 6 8
DES status
CLS tld cnda fna
HUNT
KEY 0 scr 2308
To program subscriber's digital set (e.g. 4000) to hunt to voice mail pilot number: (all the rest stays
the same)
FDN 2000
.
.
CLS tld hta fna mwa cnia ccsa mra nama -> Must have for Guest Name to be
displayed
HUNT 2000
To program subscriber's analog set (e.g. 5000) to hunt to voice mail pilot number: (all the rest stays
the same)
TYPE 500
.
DN 5000
.
CLS tld lpa hta fna mwa cnia ccsa mra nama -> Must have for Guest Name to be
displayed. LPA is necessary for the MWL to work on analog sets.
HUNT 2000
.
FTR fdn 2000
To check whether Phantom Superloops have been defined (for TUI and AA):
>ld 97
REQ prt
TYPE supl
To create Phantom Superloops:
>ld 97
REQ chg
TYPE supl n96
To list unassigned Phantom TNs:
>ld 20
REQ luu
TYPE 500
Nortel Hospitality Messaging Server 400
Installation and Configuration Guide
-> Depending on which loop and slot the Digital
LC is installed in
-> Any name will do
-> Must have
-> No Hunt
-> Own DN
-> Forward to Voice mail Pilot Number
-> Hunt to Voice mail Pilot Number
-> Analog Set
-> Hunt to Voice mail Pilot Number
-> Forward to Voice mail Pilot Number
April 2006
-37-