Nortel HMS400 Installation And Configuration Manual page 50

•
•
The following diagram shows how to remove the side panel. See the instructions for removal
below.
1. Place the server on its side on your working surface.
2. Turn the two thumbscrews on the back of the server counter-clockwise to loosen them.
Note: The thumbscrews are not removable.
Note: If a removable screw is present, remove it. This screw secures the cover to the
server during shipping.
3. Place your fingertips in the depression on the side cover, and then as you apply pressure,
pull the cover approximately 2.5 cm (1 in.) away from the front of the server until it stops.
4. Use one hand to pull the top edge of the cover away from the server to disengage the top
row of tabs on the cover from the notches in the chassis.
5. Use both hands to lift the cover upward to disengage the bottom row of tabs from the
notches in the chassis.
6. Set the cover aside.
7. Continue with "Inspecting the server interior" on next section.
Nortel Hospitality Messaging Server 400
Installation and Configuration Guide
CAUTION
Risk of equipment damage
Use an ESD wrist strap to protect static-sensitive
components.
Place the server on its side to prevent the server from
accidentally falling over. This provides greater stability. If
you attempt to work with the server in its standing position,
it may tip over when you work with the interior
components.
April 2006
-50-