Suspended Ceiling Installation-Drop Ceiling Tiles - Nortel 2332 Installation Manual

12 Lock the AP onto the bracket by inserting the 3-mm or 1/8-inch screwdriver into the Lock hole on the
access point as shown in
Warning!
fully locked onto the bracket before releasing it.
Figure 12. Step 12—Locking the Bracket
13 To ensure that the AP is fully locked onto the bracket, gently pull down on the access point and attempt to
rotate it from side to side.
14 If the access point comes off the bracket, relock the device onto the bracket as described in
page 41.
15 If the other end of the Cat-5 cable is not already connected and the link activated, go to
AP to a WSS" on page
Suspended ceiling installation—drop ceiling tiles
(For required mounting hardware and tools, see
1
Select an installation location that is centered over a T-bar in the ceiling.
2
Cut a hole as follows in the ceiling tile for the Cat-5 cable:
a
Place the mounting template over the area where you plan to install the AP.
b
Use the box cutter to cut along the line marking the opening for the point connectors.
c
Remove the mounting template and the material you cut from the ceiling panel.
3
Install the T-bar clamp that fits the T-bar:
Installing and connecting a Series 2332 Access Point 41
Figure 12.
To prevent possible damage to the AP, make sure the device is
Lock
T-bar
53. Otherwise, go to
Table 3 on page
Nortel WLAN Series 2332 Access Point Installation Guide
"Verifying AP health" on page
36.)
step 12 on
"Connecting an
55.