Nortel 2332 Installation Manual page 51

5
As shown in
universal mounting bracket over the drywall anchors so that the two screw holes in the bracket face the
drywall anchors.
6
Insert the #6 sheet metal screws into the screw holes, and tighten them to secure the universal mounting
bracket to the wall or ceiling.
(If you routed the Cat-5 cable through a hole in the wall or ceiling, insert the screw into the center screw
hole only.)
Note.
are the holes indicated by the dashed lines in
holes. They are not screw holes.
Figure 27. Steps 5 and 6—Bracket Placement on Solid Wall or Ceiling
7
As shown in
Installing and connecting a Series 2332 Access Point 51
Figure 27 on page 51, feed the Cat-5 cable through the port connector opening and align the
Do not insert screws in the four holes on the edges of the bracket. (These
Figure 28, insert the Cat-5 cable into the connector:
Nortel WLAN Series 2332 Access Point Installation Guide
Figure 27.) The AP fits into these