Junction Box Installation - Nortel 2332 Installation Manual

46 Installing and connecting a Series 2332 Access Point
Figure 20. Step 10—Locking the Bracket
12 To ensure that the AP is fully locked onto the bracket, gently pull down on the access point and attempt to
rotate it from side to side.
If the access point comes off the bracket, relock the device onto the bracket as described in
page 40.
13 If the other end of the Cat-5 cable is not already connected and the link activated, then go to
an AP to a WSS" on page

Junction box installation

(For required mounting hardware and tools, see
1
Unlock the universal mounting bracket from the AP by inserting the 3-mm or 1/8-inch screwdriver into
the Unlock hole on the AP as shown in
Caution!
components, do not use excessive force when inserting a tool into the Unlock or
Lock hole.
NN47250-302 (324136-A Version 01.03)
Lock
T-bar
53. Otherwise, go to
Table 3 on page
Figure
To avoid damage to the AP's lock mechanism or electronic
"Verifying AP health" on page
36.)
21.
step 11 on
"Connecting
55.