Fcc Caution; Deployment Statement; Canadian Ic Statement - Nortel 2332 Installation Manual

8
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
RF Radiation Exposure & Hazard Statement
To ensure compliance with FCC RF exposure requirements, this device must be installed in a location such that the
antenna of the device will be greater than 20 cm (8 in.) away from all persons. Using higher gain antennas and types of
antennas not covered under the FCC certification of this product is not allowed. Installers of the radio and end users of
the product must adhere to the installation instructions provided in this manual.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Non-Modification Statement
Use only the supplied internal antenna, or external antennas supplied by the manufacturer. Unauthorized antennas,
modifications, or attachments could damage the WLAN 2332-A1 and related Series 2332 access points and violate FCC
regulations. Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this equipment. Contact Nortel for a list of approved 2.4 GHz and 5.0 GHz external
antennas.
This device must be operated with the CAT-5 Ethernet cable installed on each activated Ethernet Port of a Series 2332
access point to ensure compliance with the Class B emissions standards. Failure to comply with this installation
requirement may cause the device to operate in excess of the allowable emissions limits.

Deployment Statement

This product is certified for indoor deployment only. Do not install or use this product outdoors.
Dynamic Frequency Selection (DFS) in the 5.0 GHz UNII bands
The 2332-A1 access point has been prohibited, via software, from operating in the 5250 to 5350 MHz and
5470 to 5725 MHz frequency bands for the US and Canada because it cannot meet the DFS requirements as outlined in
the rules of the FCC for Part 15, Subpart E that come into force on July 20, 2007.

Canadian IC Statement

Operation is subject to the following two conditions in Canada:
1) this device may not cause interference, and
2) this device must accept any interference, including interference that may cause undesired operation of the
device
To prevent radio interference to the licensed service (i.e. co-channel Mobile Satellite systems) this device is intended to
be operated indoors and away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is
installed outdoors is subject to licensing and not supported by the WLAN Access Point 2332-A1.
NN47250-307 (324136-A Version 01.03)