Nortel 2332 Installation Manual page 40

40 Installing and connecting a Series 2332 Access Point
Figure 10. Step 7—Bottom View
Port connector
opening
8
Pull the Cat-5 cable about 15 cm (about 6 inches) out of the hole in the ceiling tile and through the port
connector opening to create enough slack to insert the cable.
9
Insert the Cat-5 cable into the connector:
10 Install the Kensington lock (optional).
a
Loop the Kensington lock's cable around an object that cannot be moved or damaged by a person
pulling on the cable.
b
Insert the key into the Kensington lock.
c
Insert the Kensington lock into the security slot on the AP.
d
Rotate the key right or left to secure the lock to the AP.
e
Pull on the lock to verify that it is secured to the AP.
f
Remove the key.
11 Lift the AP into place on the universal mounting bracket as shown in
Make sure the cable feeds properly into the ceiling as you lift the device, and does not become trapped
between the access point and the bracket.
Figure 11. Step 11—Placing the AP on the Bracket
NN47250-302 (324136-A Version 01.03)
Universal mounting bracket
T-bar
Figure 11 on page 40.