Nortel 2332 Installation Manual page 54

54 Installing and connecting a Series 2332 Access Point
Figure 30 shows how to insert a Cat-5 cable into a 10/100 Ethernet port on a WSS. Refer to this figure as you perform
the procedure.
Figure 30. 10/100 Cat-5 Cable Installation
1
Insert a Cat-5 cable with a standard RJ-45 connector as shown in
the supplied Cat-5 straight-through cable.
2
When the link is activated, observe the AP LED for the port on the WSS:
AP LED Appearance
Solid green
Alternating green and amber
Solid amber
Blinking amber
Unlit
NN47250-302 (324136-A Version 01.03)
Meaning
For an AP's active link, all the following are true:
• AP has booted.
• AP has received a valid configuration from the WSS.
• Management link with an AP is operational.
• At least one radio is enabled or is in sentry mode.
For an AP's secondary link, the link is present.
AP is booting with an image received from the WSS.
After the access point boots and receives its configuration,
this LED appearance persists until a radio is enabled or is
placed in sentry mode.
PoE is on.
AP is unresponsive or there is a PoE problem.
PoE is off.
Figure 30. For connection to an AP, use