Nortel 2332 Installation Manual page 44

44 Installing and connecting a Series 2332 Access Point
c
Rotate the universal mounting bracket clockwise until the flanges snap into place on the T-bar clamp
as shown in
Figure 17. Step 6—Top View
Universal mounting
bracket
T- bar
T-bar clamps
(attached
to T-bar)
Port connector
opening
(Viewed from above ceiling tiles, looking down.)
Figure 18. Step 6—Bottom View
Port connector
opening
7
Pull the Cat-5 cable about 15 cm (about 6 inches) out of the hole in the ceiling tile and through the port
connector opening to create enough slack to insert the cable.
8
Insert the Cat-5 cable into the connector.
9
Install the Kensington lock (optional).
a
Loop the Kensington lock's cable around an object that cannot be moved or damaged by a person
pulling on the cable.
b
Insert the key into the Kensington lock.
c
Insert the Kensington lock into the security slot on the AP.
d
Rotate the key right or left to secure the lock to the AP.
NN47250-302 (324136-A Version 01.03)
Figure 18 on page 44.
Universal mounting bracket
T-bar