Table of Contents
Advertisement
Proflame II Remote Control Operating Instructions
IMPORTANT:The Proflame Transmitter 2 is an integrated part of the
Proflame 2 System, which consists of these elements:
•
Proflame 2 Transmitter, to be used in conjunction with:
•
Integrated Fireplaces Control (Proflame 2 IFC)
The Proflame 2 Transmitter provides for controlling the following hearth
appliance functions:
1.
Main Burner On/Off
2.
Main Burner flame modulation (6 levels)
3.
Choice of standing or intermittent pilot (CPI/IPI)
4.
Thermostat and Smart thermostat functions
5.
Accent light modulation (6 levels)
6.
Comfort Fan speed modulation (6 levels)
The Proflame Transmitter uses a streamline design with a simple button
layout and informative LCD display (Fig. 1). A Mode Key is provided to
index between the features and a Thermostat Key is used to turn on/
off or index through Thermostat functions (Fig. 1 & 2). Additionally, a
Key Lock feature is provided (Fig. 21).
Figure 1: Proflame Transmitter
Figure 2: Transmitter LCD Display
operating instructions
TECHNICAL DATA
REMOTE CONTROL
Supply Voltage
Ambient temperature
ratings
Radio Frequency
WARNING: THE TRANSMITTER AND RECEIVER ARE RADIO
FREQUENCY DEVICES. PLACING THE RECEIVER IN OR
NEAR METAL MAY SEVERELY REDUCE THE SIGNAL RANGE.
ATTENTION!
- Turn "OFF" the main gas supply of the appliance during installation or
maintenance of the Receiver device.
- Turn "OFF" main gas supply to the appliance prior to removing or
reinserting the batteries.
- In case of remote control malfunction, turn off the IFC device using
the "ON/OFF" main switch.
- For installation / maintenance, switch off the IFC device removing
main power supply plug.
Operating Procedure
Initializing the System For the First Time
Power the receiver. Press the reset button located on front right-hand
corner of the unit. The Receiver will "beep" three (3) times to indicate
that it is ready to synchronize with a Transmitter. Install the 3 AAA type
batteries in the Transmitter battery bay, located on the base of the
Transmitter. (fig. 3) With the batteries already installed in the Transmit-
ter, push the On button. The Receiver will "beep" four times to indicate
the Transmitter's command is accepted and sets to the particular code
of that Transmitter. The system is now initialized.
Figure 3: Battery Compartment
Regency GFi750 Gas Inbuilt Fireplace
4.5V (three 1.5V AAA batteries)
0 - 50
C (32 - 122
F)
o
o
433.92 MHZ
|
25
Advertisement
Table of Contents
