Table of Contents
Advertisement
Proflame II Remote Control Operating Instructions
IMPORTANT:The Proflame Transmitter 2 is an integrated part of the
Proflame 2 System, which consists of these elements:
•
Proflame 2 Transmitter, to be used in conjunction with:
•
Integrated Fireplaces Control (Proflame 2 IFC)
The Proflame 2 Transmitter provides for controlling the following hearth
appliance functions:
1.
Main Burner On/Off
2.
Main Burner flame modulation (6 levels)
3.
Choice of standing or intermittent pilot (CPI/IPI)
4.
Thermostat and Smart thermostat functions
5.
Accent light modulation (6 levels)**
6.
Split flow valve**
7.
Comfort Fan speed modulation (6 levels)**
** This feature is not available on any Hampton models.
The Proflame Transmitter uses a streamline design with a simple button
layout and informative LCD display (Fig. 1). A Mode Key is provided to
index between the features and a Thermostat Key is used to turn on/off
or index through Thermostat functions (Fig. 1 & 2). Additionally, a Key
Lock feature is provided (Fig. 22).
Figure 1: Proflame Transmitter
Figure 2: Transmitter LCD Display
TECHNICAL DATA
REMOTE CONTROL
Supply Voltage
4.5V (three 1.5V AAA batteries)
Ambient temperature
0 - 50
ratings
Radio Frequency
433.92.MHZ
WARNING: THE TRANSMITTER AND IFC ARE RADIO FRE-
QUENCY DEVICES.
ATTENTION!
- Turn "OFF" the main gas supply of the appliance during installation or
maintenance of the IFC.
- Turn "OFF" main gas supply to the appliance prior to removing or rein-
serting the batteries.
- In case of remote control malfunction, turn off the IFC device using the
"ON/OFF" main switch.
- For installation / maintenance, switch off the IFC device removing main
power supply plug.
This appliance requires coding/pairing of the remote control and IFC
(Integrated Fireplace Control).
See remote/IFC coding/pairing instructions found in this manual.
Initializing the System for the First Time
Power the receiver. Press the PRG button located on the top right hand
corner of the receiver - see the receiver instruction marked (*). The re-
ceiver will beep three times to indicate that it is ready to synchronize with
a transmitter. Install the 3 AAA type batteries in the transmitter battery
bay, located on the base of the transmitter (fig. 3). With the batteries
already installed in the transmitter, opush the ON button. The receiver's
command is accepted and sets to the particular code of that transmitter.
The system is now initialized.
(*) The receiver may be independent or integral jto the IFC hearth appli-
ance control module. The receiver instruction may not be independent
when part of the IFC.
Figure 3: Battery Compartment
owner's information
C (32 - 122
F)
o
o
City Series ACB60E | 13
Advertisement
Table of Contents
