Table of Contents
Advertisement
Copy of Lighting Instruction Plate
FOR YOUR SAFETY READ BEFORE LIGHTING
SUITABLE ONLY FOR INDOOR INSTALLATION
This appliance must be installed in accordance
with local codes, if any; if not,
follow the current AS/NZS 5601
WARNING:
If you do not follow these
instructions exactly, a fire or explosion may
result causing property damage, personal injury
or loss of life. Improper installation, adjustment,
alteration, service or maintenance can cause
injury or property damage. Refer to the owner's
information manual provided with this appliance.
For assistance or additional information consult a
qualified installer, service agency or gas supplier.
A) BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the
floor.
WHAT TO DO IF YOU SMELL GAS
- Do not try to light any appliance
- Do not touch any electric switch, do not use
any phone in your building
- Immediately call your gas supplier from a
neighbors phone. Follow the gas supplier's
instructions.
- If you cannot reach your gas supplier, call the fire
department.
B) Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of
the control system and any gas control which has
been under water.
This appliance needs fresh air for safe operation and
must be installed so there are provisions for adequate
combustion and ventilation air.
CAUTION: Hot while in operation. Do not
touch. Severe Burns may result. Due to high
surface temperatures keep children, clothing
and furniture, gasoline and other liquids having
flammable vapors away. Keep burner and
control compartment clean. See installation and
operating instructions accompanying appliance.
LIGHTING INSTRUCTIONS
STOP! Read the safety information above on this label.
1)
Ensure the Main switch is in the ON position
and/or the wall mounted battery holder (if
equipped) is in the <REMOTE> position.
2)
Press and release the ON/OFF button on the
remote handheld transmitter. The receiver will
beep. If not using the remote, the unit can be
turned on by sliding the battery holder switch
to the <ON> position (if equipped).
3)
After approximately 4 seconds the spark igni-
tion system will spark for 60 seconds to light
the main burner.
4)
The unit will turn on.
Note: The first attempt to ignition will last
approximately 60 seconds. If there is no flame
ignition (rectification) the board will stop
sparking for approximately 35 seconds. After
this wait time, the board will start a second try
for ignition by sparking for approximately 60
seconds. If there is still no positive ignition
after the second attempt the board will go into
lock out. The system will need to be reset as
follows (after going into lock out mode):
a) Wait 5 minutes - turn the system off by press-
ing the ON/OFF button on the remote.
b) After approximately 2 seconds, press the ON/
OFF button again.
c) Unit will repeat step 2.
TO TURN OFF GAS APPLIANCE
1)
Press the ON/OFF button once.
2)
Turn off all electric power to the unit if service
is to be performed.
DO NOT REMOVE THIS
INSTRUCTION PLATE
operating instructions
920-463
Regency GFi750 Gas Inbuilt Fireplace
|
23
Advertisement
Table of Contents
