Initial Setting - Pentax R-2501NS Instruction Manual

Pressing again the [ESC] key or [ENT] key quits the
initial setting screen and usual start screen appears.

8.8 Initial setting 1

1. Selection of Atmospheric Correction: [ATM CORR]
Select whether Atmospheric Correction is to be performed
by using the automatic measurement correction function
with an atmospheric sensor, by entering the atmospheric
temperature and pressure measured with a thermometer
and barometer, by entering ppm value, or by fixing the
ppm value to 0 (NIL) not to perform Atmospheric Correction.
2. Selection of Prism Constant: [PRISM CONST.]
Select whether the Prism Constant to be input is set to
0mm, -30mm or to an arbitrary value to be entered from
the keyboard.
3. Selection for Reflector sheet Constant
: [SHEET CONST]
Select whether the target constant to be input is set to
0mm, or to an arbitrary value to be entered from the
keyboard.
4. Selection for Refraction & Curvature Corrections
: [CRV/REF CORR]
Select whether the correction factor to be input for both
differences (Refraction, Curvature) is set to 0.14, 0.2 or
none (NIL). Selecting "3. NIL" results in no correction of
both values.
5. Selection of Tilt Compensation: [COMP AXIS]
Select whether Tilt Compensation is to be single-axis compensation, dual-axis
compensation, or disabled (NIL).
※R-2501NS、R-2502NS：３AXIS
R-2503NS、R-2505NS：２AXIS
• The factory default for each instrument condition is marked by
X1.AUTOXXXXXXXXX
2.ATM INPUT
3.ppm INPUT
4.NIL
X1.-30mmXaXXXXXX
2. 0mm
3.INPUT
X1. 0mmXaXXXXXX
2. INPUT
X1.0.14 XaXXXXXX
2.0.2
3.NIL
X1.2 AXISXXXXXXX
2.1 AXIS
3.NIL
.
43